You are here

Sampling Inspection Procedures, Part 1: Attribute Sampling Plans Indexed by Acceptable Quality Limit (AQL) for Lot-by-Lot Inspection

Scope 1.1

This part of ISO 2859 specifies an acceptance sampling system for inspection by attributes. It is indexed in terms of the acceptance quality limit (AQL). Its purpose is to induce a supplier through the economic and psychological pressure of lot non-acceptance to maintain a process average at least as good as the specified acceptance quality limit, while at the same time providing an upper limit for the risk to the consumer of accepting the occasional poor lot.

Sampling schemes designated in this part of ISO 2859 are applicable, but not limited, to inspection of

end items, components and raw materials, operations, materials in process, supplies in storage, maintenance operations, data or records, and administrative procedures.

These schemes are intended primarily to be used for a continuing series of lots, that is, a series Ions enouah to allow the switching rules (9.3) to be applied.

These rules provide: - a) a protection to the consumer (by means of a switch to tightened inspection or discontinuation of sampling inspection) should a deterioration in quality be detected;

b) an incentive (at the discretion of the responsible authority) to reduce inspection costs (by means of a switch to reduced inspection) should consistently good quality be achieved.

Category: 
Management & Systems
Standard Number: 
IS 2500-1
Click Here to View

Share this page